DMX Shield /Expansion board module Compatible for Arduino 1.0 for DMX-Master device / artwork into DMX512 networks

New

$17.51

/ $18.43

In stock


Product Description
100% Genuine DMX Shield / Expansion board module Compatible for Arduino 1.0 for DMX-Master device / artwork into DMX512 networks
Introduction
The DMX-shield is an add-on (or "shield") Compatible for Arduino. It is an easy way to use the for Ardulno as a DMX-Master device, just by adding the DMX-shield on the top of the for Ardulno.
This DMX / RDM Shield is a low cost high quality solution that allows you to connect your for Ardulno driven artwork into DMX512 networks. The shield is populated with high quality NEUTRIK XLR 3pin Connectors (1x male and 1x female). The MAX485 based shield can be used as DMX Master, Slave and as RDM transponder.A unique RDM device id will be handed out from out range to you as well, this will make your device worldwide unique.
The following settings are configurable via the onboard jumpers:
Send data via TX or Digital pin 4
Receive data via RX or Digital pin 3
Hardware slave mode or Software Controlled Slave/Master via Digital pin 2 (Required for RDM)
Enable / Disable shield In case you have the shield configured to use the RX and TX pins you have to disable the shield before you can upload your new sketch onto the for Ardulno board. This jumper allows you to disable the shield without disconnecting it from the for Ardulno board which saves time

Tags: module dmx, shield for arduino, module board, Cheap module dmx, High Quality shield for arduino, China module board Suppliers

Unit Type piece
Package Weight 0.05kg (0.11lb.)
Package Size 10cm x 10cm x 10cm (3.94in x 3.94in x 3.94in)
Type Voltage Regulator
Brand Name gcsupermarket
Condition New
application other
is_customized yes

Write a review

DMX Shield /Expansion board module Compatible for Arduino 1.0 for DMX-Master device / artwork into DMX512 networks

DMX Shield /Expansion board module Compatible for Arduino 1.0 for DMX-Master device / artwork into DMX512 networks

Product Description 100% Genuine DMX Shield / Expansion board module Compatible for Arduino 1.0 for DMX-Master device / artwork into DMX512 networks Introduction The DMX-shield is an add-on (or shield ) Compatible for Arduino. It is an easy way to use the for Ardulno as a DMX-Master device, just by adding

Related products